Joined: Jan 2023. Location: Estonia. Reputation: 0. #1. 20-01-2023, 11:26 AM. Hi, my Berlingo showed the yellow warning light with a text with it that said engine fault, it turned off, but came back again. Now the engine lost power and will not go past 3-3,5k RPM. Anybody had the same problem and what would I have to look for. Engine goes into limp mode same code appears. Does the 1.6 hdi engine suffer with fuel pressure faults at this sort of mileage. It’s serviced with genuine parts every 10k with the best quality oil and always use shell diesel not supermarket rubbish. The car seems to be running fine but just lacking that 'power' it did have. I have had it hooked up to diagnostics at my garage and it has come up with fault code p0299. I believe this is low turbo pressure boost. The turbo/pipes etc has been checked for leaks and all seems fine. I have been told that it is going to need a new turbo with a When your OBD-II equipped vehicle exhibits a code P0215, it means that the powertrain control module (PCM) has detected a malfunction in the shutoff solenoid for the engine. Most commonly, the engine shutoff solenoid interferes with the fuel supply to the engine under certain specific circumstances. These circumstances may include (but are not Pretty easy task, jack it up, wheel off, take old sensor off and put new one on and connect up, which I did with relatively little bother (have done this stuff before). Started up and still flashing up with warnings. Erased the fault codes, restarted, still getting ABS warning - rear RH speed sensor!! Reputation: 0. #1. 06-07-2018, 06:40 PM. i got a problem of a fault code P1351 code and the engine would not start, the engine is cranking , and the starter & battery are good , it has suddenly got this issue , despite i had done a + 70km journey for my work ( while is routine) , the oil seal injector 1,2 are leaking oil a bit much which make I've attached the short Citroen tech guide to help troubleshoot this issue where the engine stalls. Mainly it shows the codes you would get and a short pointer list of items to check. It's basic but is meant to home in on the expected areas. Engine stops or stalls.pdf (Size: 234.95 KB / Downloads: 18) _____ Lexia shows me P0402 - EGR flow incorrect - permanent fault. So far I tried -> cleaening the strainer in tank and check every hose if did not lose the connection. But of course I found nothing. yesterday I have decided to blind the EGR, cleared the faults, for about 20 kilometers ok, then lost power and about 100km got the engine led. .

engine fault citroen berlingo 1.6 hdi